Bassot ›

SVT-CL:n manuaalissa toisella sivulla sanotaan (vapaasti englannista kääntäen) "impedanssin pitää olla sama tai suurempi kuin nimellis-impedanssi", eli tästä voisi saada sen käsityksen että 8 ohmia olisi OK 4:n ohmin asetuksella, optimaalinen se ei kuitenkaan ole, se on selvää.
 
Tuon sun käännökses voisi tulkita myös, että "vahvistimesta valitun impedanssin pitää olla sama tai suurempi kuin kaapin nimellis-impedanssi" Näin sen minun nähdäkseni pitäisi olla...
 
EDIT: On kyllä varsin epäselvä tuo ampegin manuaalin teksti...
 
EDIT2: lainaanpa nyt vielä tuon geofexin teksin tänne:
"It's almost never low impedance that kills an OT, it's too high an impedance.
 
The power tubes simply refuse to put out all that much more current with a lower-impedance load, so death by overheating with a too-low load is all but impossible - not totally out of the question but extremely unlikely. The power tubes simply get into a loading range where their output power goes down from the mismatched load. At 2:1 lower-than-matched load is not unreasonable at all.
 
If you do too high a load, the power tubes still limit what they put out, but a second order effect becomes important.
 
There is magnetic leakage from primary to secondary and between both half-primaries to each other. When the current in the primary is driven to be discontinuous, you get inductive kickback from the leakage inductances in the form of a voltage spike.
 
This voltage spike can punch through insulation or flash over sockets, and the spike is sitting on top of B+, so it's got a head start for a flashover to ground. If the punchthrough was one time, it wouldn't be a problem, but the burning residues inside the transformer make punchthrough easier at the same point on the next cycle, and eventually erode the insulation to make a conductive path between layers. The sound goes south, and with an intermittent short you can get a permanent short, or the wire can burn though to give you an open there, and now you have a dead transformer.
 
So how much loading is too high? For a well designed (equals interleaved, tightly coupled, low leakage inductances, like a fine, high quality hifi) OT, you can easily withstand a 2:1 mismatch high.
 
For a poorly designed (high leakage, poor coupling, not well insulated or potted) transformer, 2:1 may well be marginal. Worse, if you have an intermittent contact in the path to the speaker, you will introduce transients that are sharper and hence cause higher voltages. In that light, the speaker impedance selector switch could kill OT's if two ways - if it's a break befor make, the transients cause punch through; if it's a make before break, the OT is intermittently shorted and the higher currents cause burns on the switch that eventually make it into a break before make. Turning the speaker impedance selector with an amp running is something I would not chance, not once.
 
For why Marshalls are extra sensitive, could be the transformer design, could be that selector switch. I personally would not worry too much about a 2:1 mismatch too low, but I might not do a mismatch high on Marshalls with the observed data that they are not all that sturdy under that load. In that light, pulling two tubes and leaving the impedance switch alone might not be too bad, as the remaining tubes are running into a too-low rather than too-high load. "