Kitarat: kitarakamat ›

Aging
 
Before the introduction of alnico magnets in 1935, permanent magnets were not quite that permanent. During a certain time, they lost a good amount of magnetism till they finally reached a stable condition. The process to accelerate this decay was called in the industry, "magnetic aging." In modern science, it is called "stabilizing." Since the 50's, we use Alnico 5 magnets which lose, under normal conditions, less then half a percent per 100 years.
 
How do we achieve normal conditions?
 
Alnico magnets are shipped by the manufacturer in a non-magnetized condition and will not be magnetized until a pickup is completed.
 
How to maintain normal conditions?
 
After magnetization, avoid any close contact with other pickups or magnets facing either north to north or south to south with their magnetic poles. Don't ever throw pickups random in a drawer; you may either use a keeper on each side of the magnetic poles or carefully place them with the north facing the south pole of the other magnet. ( For tele players, remember that the iron backplate of a traditional tele pickup functions as a keeper which increases the stability of the magnets.)
 
Once pickups are in a guitar, there is very little to worry about. That your pickups lose some of their magnetism when you lean your guitar against an amp is nothing but a fairy tale. Or, that pickups lose some of their magnetism when you drop them on a concrete floor is just another fairy tale -- alnicos and ferrites will break before they have any measurable losses. Magnets are sensitive to heat, but so is your guitar. However, heat can be a severe problem when an Alnico 5 magnet is exposed to temperatures above 1000 F, approaching its Curie temperature of 1634 F. At these temperatures, Alnico 5 undergoes structural changes and cannot be re-magnetized. Why do I mention this? Because it happens quite often, when someone doesn't like the unbalance in output of a pickup with staggered magnets and goes to a bench grinder or a belt sander to grind a magnet down. You take a chance that a magnet gets too hot and becomes damaged.
 
http://www.billlawrence.com/Pages/Pickupology/magnets.htm