http://www.webervst.com/sptalk.html Tuolta osui silmään tällanen: From: Gerald C. Lopez
I have two 8 Ohm speakers that I can wire either parallel or series to my tube amp for an impedance of either 4 or 16 Ohm. My amp has both 4 and 16 Ohm output taps. Are there any sonic differences or benefits of series over parallel wiring or vice versa?
Gerald, connecting two speakers in parallel is an old trick to smooth out speaker response and enhance the damping of either speaker. HIFI designers took it one step further by connecting two speakers of different sizes in parallel. A speaker has a large impedance increase at its fundamental resonance, and depending on the installation, this can cause the speaker to sound boomy or out of control. By connecting two speakers in parallel, particularly two speakers of different sizes with different resonant frequencies, each speaker will tend to quench or dampen the boominess of the other. Since no two speakers are exactly alike, even two of the same size, that damping will occur, however slight, for any speakers connected in parallel. For speakers connected in series, there appears to be less control, and more of what is called 'back EMF' from the speakers fed back into the output circuit. While that seems rather chaotic, many players prefer the series connection, as it gives them a more textured tone, enhanced breakup, and overall a more desireable tone for guitar work. It's totally subjective, of course, and many factors affect the end result, such as voice coil size, gap energy, closed back/open back, output circuit damping, etc. The best thing to do, in my opinion, is try both arrangements since you have the luxury of impedance tap selection, and go with the configuration you like the best. Oletteko huomanneet samojen elementtien rinnan- ja sarjaankytkennän välillä jotakin eroa soundissa? Ihmiskunta on ylittänyt rajan. Pakokeinoja nopeutuvalta tuhoutumiselta säästymiseksi ei ole. |
ReBeat
kulmahiomakone