Media ja viihde ›

http://muusikoiden.net/keskustelu/p … 3&o=0&x=28023b363e&co=0
 
Masters for vinyl records should be pre-mastered in the correct running order with 3 to 4 seconds of silence between tracks and 30 seconds of silence between sides. (We can do this for you at an extra charge)
Sample rates should be the same, at least per side.
Limit the duration of a side to 9 minutes at 45 rpm and 14 minutes at 33 rpm. (Do not exceed 7 and 12 minutes if you want loud "dance"-levels .) Please remember that a vinyl record is an analogue medium. On CD you can get away with almost anything, a vinyl record has limitations. Remember vinyl-rule number one: longer sides means lower levels.
Please balance the duration of the sides, i.e. not side A: 7 minutes, side B: 20 minutes.
Beware of extremes, low frequencies take more space on the disc than mid- and high frequencies (fig 1), so they will fill the disc sooner, i.e reducing the available playing time at the choosen level or forcing the cutting engineer to reduce the level to fit the track(s) on the side of the disc.
Excessive high frequencies may overheat the cutting head or even clip a 1000 Watt cutting amp (remember the RIAA curve gives about 18 dB boost at 18 kH) or give rise to distortions on playback (fig 2) forcing the cutting engineer to limit or lower the amount of top or lower the overall level.
Keep your bass (all instruments with lots of low frequencies) in the middle of your mix, avoid excessive stereo separation and watch out for bad phase-relationships. Excessive stereo separation and out of phase signals, particulary at low frequencies, can result in grooves on the disk that have large vertical excursions. A groove wil be created that varies from the very deep to the very shallow with the cutting head sometimes even leaving the surface of the laquer completely (fig 3). If the width across the top of the narrowest portion of the groove is less than 25 µ, there is a high probability that the playback stylus will jump completely out of the groove. On some turntables with an ideal tone-arm/cartridge resonance frequency, this shallow groove may play through,provided that it is not too long, albeit with some sort of click or noise representing the missing portion of the groove. Some cartridges may have difficulty in playing a groove that has large variations in depth - the result is distortion on playback.
Extreme left or right panning results in large out-of-phase signals and complex record grooves wich may create moulding problems (fig 4).
Most of these problems can be avoided by checking your mix in mono and making small alterations to make your mix better mono-compatible, a better mono-compatible mix usually also sounds better in stereo.
 
Do not try to compensate for possible losses; it will usually make matters worse. Beware of distorted sounds, they will maybe still sound OK to you om your digital master but by the analogue nature of the vinyl record any distortions might increase during the process and end up totaly unacceptable on the final pressing. We receive a lot of CDR's with heavy overloads, please, please don't use your AD as a limiter: overload still this means DISTORTION. This distortion increases with every digital or analogue processing or copying/disc-cutting. You don't have to squeeze the last digital word out of your AD, the digital level on your CDR-Master has nothing to do with the Loudness of your future vinyl record. Remember they are two completely different media. The level of your vinyl disc depends on the total playingtime, the frequency-content and the dynamics of your music.

Jaha??!

Niin?

Hyvinhän se meni.