Muusikoiden.net - Keskustelu
Kirjoittaja:skebajaba
Alue:Elektroniikka ja soitinrakennus
Aihe:Bias Point
Aika:13.01.2007 15:17
noniin.
nyt lähdetään kohti treenistä.
käänsin tuon ranskankielisen pätkän englanniksi ja tälläinen oli lopputulos.
 
"Useful information for the landlords of this amplifier (version head or combo) eager to check the bias or to regulate it during a change of loudspeaker tubes.
Remove the back protective grille, you will find two Phillips screws for the adjustment of the bias.
Between these 2 screws, 3 pins are, of which the 2 external ones correspond to the points of measurement of bias of each lamp, that of the medium being the “common” point
To measure, use a multimeter regulated on the reading of mV cd.
The amplifier must be lit, connected to the HP and all the adjustments on “0”
Pose the negative probe on the central point and the positive one on one of the 2 external points. Adjust the bias according to the characteristics of the lamp and repeat the operation on the other point.
For the values, to see URLHTTP://www.randallamplifiers.COM/bu … /warranty/manuals/RM50%20Manual.pdf /url.
These data relate to series RM of Randall, but the RH50T and RG50TC have the same voltage on the plate (450V).
Like final test, Randall recommends a measurement between the points external which should post a voltage lower than 5mV cd., revealing of a suitable apairage of the lamps.
As usual, prudence is of setting considering the voltages MORTALS which circulate in a lamp amplifier. Not question of going trifouiller on the side of the condos, nor to put the 2 hands inside the amplifier, which this operation requires besides by no means."
 
elikkä niinkuin arvelin aluksi noiden pisteiden toiminnan niin näinhän se olikin.
 
ja nyt lähden treenikselle laittamaan uudet putket kiinni ja soittelemaan.
palailen asiaan illalla ja kerron sitten kuinka helposti homma sujui.
kiitoksia vielä avuistanne
Copyright ©1999-2024, Muusikoiden Net ry. Kaikki oikeudet pidätetään.
https://muusikoiden.net/keskustelu/posts.php?c=31&t=140221